$25 off all services · online only · mention this ad ·

.png)



.png)
GENERATOR INSTALLATION
IN NORTHEAST TEXAS
Standby power sized to what your home actually needs to run, installed and inspected under the license of our master electrician of record.
A standby generator watches your power and takes over on its own when it drops. Getting one right is less about the badge on the lid and more about three things: what you actually need running, which utility feeds the property, and whether the work gets permitted and inspected. That is the job we do.

Free in-home generator assessment
Office Hours: Mon-Fri 7am-5pm
Permits pulled and inspections booked


WHOLE HOUSE, OR JUST THE CIRCUITS THAT MATTER
There are two honest ways to do this, and the right one depends on your house and your budget rather than on what we would rather sell. Tap what you want running when the power is out.

COVERAGE
.png)
We will show you both options and what each one covers before you decide. No sizes or prices are quoted from a picker like this one, and none are quoted from a phone call either. The load calculation decides it.
“We size it to what you actually need powered, not to the biggest unit on the shelf.”
Whole-house backup runs everything, air conditioning included, and needs a larger unit and a bigger fuel supply.
Essential-circuit backup, which we scope at roughly 60 percent coverage, runs the things that actually hurt when they stop: the refrigerator, lights, the security system, internet, medical equipment, the well pump, heat and selected outlets. It costs less to install and less to run.


Air conditioning is usually the deciding factor in Texas. A correctly sized standby unit can carry one or more systems, and which of those is realistic falls out of the load calculation rather than out of a brochure.

SIZED TO WHAT YOUR HOME ACTUALLY DRAWS
The most common way a standby generator goes wrong is that nobody measured anything. A unit gets picked off a shelf because it is the popular size, and the homeowner finds out in the first outage that it will not carry the well pump and the air conditioning at the same time, or that they paid for capacity they will never use.

THE METHOD
That starts with a load calculation. We work out what your home genuinely draws, which appliances have a start-up surge that matters, and what you want running when the power is out. You can have a copy of the calculation. It is your house and your number, and it is the document that tells you whether a quote you are comparing is realistic. If the calculation says a smaller unit does what you need, we will tell you that.

.png)

.png)
PERMITS & APPROVALS
WE HANDLE THE PAPERWORK, AND WE TELL YOU WHICH PAPERWORK THERE IS
A standby generator is permitted, inspected electrical work. Before we quote, we confirm which edition of the electrical code your city has adopted and what it requires for your job, so nothing turns up late.

The Permit Is Ours To Pull
Wherever your property sits on our map, we pull the electrical permit for the job and we book the inspection. Some cities want a contractor registered with them before they will issue one, and where that applies we take care of it. It is part of the job, not an errand we hand back to you.
Unincorporated county addresses run their own process, and it is not always the same as the nearest city’s. Tell us the address and we will confirm the route before anything is scheduled.

and Surrounding Areas →

Also serving:

Heath

Point

Kaufman

Forney

Emory

Princeton

Terrell

Wylie

Plano

Commerce

Wolfe City

Frisco

Sulphur Springs

Wills Point

McKinney

WHAT YOU ARE ACTUALLY CHOOSING BETWEEN
.png)
THE REAL CHOICE
Plenty of people price a generator through a big retailer, and there is nothing wrong with that. It is worth knowing what differs.
.png)
A RETAIL INSTALL PROGRAM

Sells you a unit, then assigns the electrical work to whichever contractor is on the roster that week.


The permit gets pulled by somebody you have not met.
The person who comes back when the unit throws an alert in two years is whoever is on the roster that week instead.
ONE NAMED LICENSE HOLDER

Every job we do runs under the license and standard of one master electrician of record.

The load calculation is ours, the permit is pulled in our name, and the inspection is ours to pass.

You can look the license up on the state register in about a minute, and you should, whoever you hire.

Kyle Robison · Master Electrician · TDLR #782768 LUCKY ELECTRICAL LLC · TECL #41101
Not ready for a permanent standby system? You do not have to leave the house unprotected. We install two portable-generator setups, and both are a much smaller job than a standby install.

A RETAIL INSTALL PROGRAM

A dedicated sub-panel that feeds your critical circuits safely.

You never risk overloading the portable unit.
.png)
GENERATOR INTERLOCK KIT

Fitted to your existing panel rather than adding one.

Lets you choose which circuits to power, safely, by hand.

FUEL, PLACEMENT AND WHAT WE BRING TO THE JOB
.png)
FUEL & PLACEMENT
.png)
NATURAL GAS
No tank and no refills, but it depends on the gas supply staying up.


Run time is limited by the supply, not by a tank
Nothing to monitor and nothing to top up
.png)
PROPANE
You control your own supply, and you have to keep it filled.

The tank has to be sized for the run time you expect, not for the unit alone

Worth planning around before the pad goes in
.png)
WHAT COMES OFF THE TRUCK
FLIR thermal imaging, and Klein and Ideal circuit analyzers and locators. That is how we find a marginal connection in the existing system before it becomes the generator’s problem.
Placement is governed by clearances from windows, doors and vents, and by getting a level, stable base under the unit.

LUCKY’S HONEST OPINION OF THUNDER
Our mascot is a laid-back golden retriever who loves the pool, loves anyone who will give him attention, and is not a fan of loud noises. When the sky goes off and the lights go with it, he is under something. Most households have a version of that, whether it walks on four legs or plugs into the wall.

AFTER IT IS IN

AFTERWARDS
.png)
IT TESTS ITSELF
You will hear it run on its schedule. That is the unit proving it can still start, not a fault.

YOU GET SHOWN IT
What the alerts mean, what the exercise cycle sounds like, and when it is due for service. Ours is not a fit-and-forget install.
.png)
REMOTE MONITORING, OPTIONAL
Mobile monitoring lets you and us see the unit’s status in real time, with alerts for routine self-tests and system warnings.

WE SERVICE WHAT WE INSTALL
We service and maintain the generators our team installed. If somebody else installed yours, we are not the right people to call for it.
A standby generator exercises itself on a schedule, which is the unit checking it can still do the job. It also needs servicing, because it is an engine, and engines need oil, filters and attention whether they have run much or not.

WHAT A STANDBY GENERATOR ACTUALLY COSTS
Every home’s panel, layout and gas supply are different, so the honest answer is a range and the drivers behind it.

COST
AUTOMATIC STANDBY, INSTALLED

$13,000 – $26,000
Most of our complete turnkey installations land in the middle of that range. We quote the job rather than the hour, and we run the load calculation before we quote so the number is built on your house instead of an average. What this range assumes. These figures are based on a standard-size single-family home. A larger home, a longer run between the unit and the panel, a heavier set of loads or gas work that does not exist yet will all move the number. Your load calculation settles it, and you see the price in full before any work starts.

WHAT MOVES THE NUMBER

How much of the house you want running

Natural gas or propane, and whether the gas line already exists

How far the unit sits from the panel and the fuel supply

Whether your existing panel and service have the capacity to take it

$0 IN-HOME ASSESSMENT
$0 CHARGE
There is no charge for the visit. We would rather look at your panel, work out what you actually need and earn the job than charge you to find out. The portable setups further up the page are a different and much smaller job and are not covered by the range on the left.

3 THINGS WE PUT IN WRITING
Every installation carries these. They are not conditional on the size of the job.

WHAT YOU ARE COVERED BY

THE QUESTIONS PEOPLE ACTUALLY TYPE

QUESTIONS
The honest answer is that it depends on four things, and any number quoted without them is a guess. Those are: how much of the house you want running, whether the unit runs on natural gas or propane, how far the generator sits from the panel and the fuel supply, and whether your existing panel and service have the capacity to take it.
Automatic standby installations generally run between $13,000 and $26,000 installed, and most of our complete turnkey jobs land in the middle of that range. We quote the job rather than the hour, we run the load calculation before we quote, and you get the options and the price in full before any work starts. The in-home assessment is free.
Sometimes yes, and it is separate from the city permit. If your power comes from Greenville Electric Utility System, GEUS requires written approval through its Backup Power Source Application Packet before the generator is installed, and the City of Greenville electrical permit is pulled separately on top of that.
Elsewhere across this area the utility is either Oncor or Farmers Electric Cooperative, and inside the Farmersville city limits the city is the utility. Which one serves you is on your bill or your meter tag, and checking it is the first thing we do.
At least once a year, and after any heavy run. It is an engine, so it needs oil, filters and a check that the battery will still turn it over, and the annual service is also when the transfer switch and connections get looked at.
The unit will exercise itself on a schedule in between, which tells you it can start but does not tell you it is maintained.
Square footage is the wrong unit to size a generator in, which is why quotes based on it vary so wildly. A 2,000 square foot home with one air conditioning system, city water and gas heat draws far less than a 2,000 square foot home with two systems, a well pump and an electric range.
What decides the size is the load calculation: what actually runs, what surges when it starts, and what you want on during an outage. We run that first, and you can have a copy of it. For the money question underneath this one, automatic standby installations generally run between $13,000 and $26,000 installed, whatever the square footage says.
At least once a year, and after any heavy run. It is an engine, so it needs oil, filters and a check that the battery will still turn it over, and the annual service is also when the transfer switch and connections get looked at.
The unit will exercise itself on a schedule in between, which tells you it can start but does not tell you it is maintained.



GET IT LOOKED AT
TALK TO THE ELECTRICIAN WHO WILL SIGN THE PERMIT
Tell us what you want running when the power goes out and we will work back from there. We will run the load calculation, show you the options and the price in full before anything starts, and confirm the appointment by text. You get a text when the electrician is on the way.
Before you call
Your in-home generator assessment is free. There is no charge to have us come out, look at your panel and work out what you need.
For other electrical service calls a dispatch fee applies. $49 Monday to Friday 7:00am to 5:00pm, credited toward the work when it proceeds. $199 outside those hours, which covers the after-hours call-out itself and is not credited toward the work.


Lucky cannot read a meter. Kyle can, and every job runs under his license and standard.

TECL #41101
© 2026 Lucky Electrical LLC. All rights reserved.
Site by





%204.png)